Since mid-October, attackers in Europe have been reaching into supermarket and cold-storage refrigeration controllers that sit open on the internet. They trigger defrost cycles nobody asked for and spoil stock. This week the problem got worse. Researchers at Dutch security firm Midnight Blue disclosed six previously unknown flaws in the Danfoss AK-SM800A, a widely used refrigeration system manager. Any of the six lets an attacker run code on the device without logging in. No patch exists, no CVE identifiers have been assigned, and Midnight Blue titled its write-up "Don't bother patching."
This week, national cybersecurity agencies in Germany and Ireland (both on Nov. 13), and Belgium according to The Hacker News, gave operators the same message: take the controllers' management interfaces off the public internet now.
This is a separate disclosure from the earlier warnings about Copeland and Dixel XWEB controllers. The attacks so far hit Danfoss and Copeland devices alike, but the sources do not tie the six new flaws to those attacks. Below is what is known and what to do about it.
What exactly was found?
Midnight Blue, with researcher Carlo Meijer credited by The Hacker News, reports six pre-authentication remote code execution (RCE) vulnerabilities in AK-SM800A firmware up to and including version 5.3.2. "Pre-authentication" means an attacker does not need a username or password. Sending the right request to the device's web interface is enough. "Remote code execution" means the attacker can then run software of their own choosing on the controller.
According to The Hacker News, five of the six flaws are in the web request handlers, the code that processes incoming web traffic. That code runs as root, the most privileged account on the device, so a successful attack gives full control rather than partial access. The sixth flaw is in the gateway component that enforces the controller's "Strict" session-control mode, a hardened setting operators might reasonably expect to protect them.
The researchers first achieved root-level code execution on older firmware, version 3.3.0. They then found the same bugs in 5.3.2, which they examined as the newest release at the time.
Is there a fixed version?
No. The confusion here is about firmware 5.4.0, which appeared in November 2026. Germany's Federal Office for Information Security (BSI) first said 5.4.0 was not affected. In an update at 13:25 on Nov. 13 it withdrew that claim and said it cannot rule out that 5.4.0 is also vulnerable. The researchers go further. Per The Hacker News, they say 5.4.0, which they believe was built around Oct. 29, does not fix the flaws. When The Hacker News reported on Nov. 16, Danfoss's security advisory page listed no advisory and no fix date for these issues.
Ireland's National Cyber Security Centre (NCSC) confirms that CVE IDs have not been assigned, no patches are available, and coordinated disclosure with the vendor is still in progress.
Why won't a factory reset clean an infected device?
Updating firmware or resetting a device to factory settings normally wipes out anything an attacker planted. Here, that may not work. The Hacker News reports the controllers lack secure boot, a hardware-backed check that only lets the device start software signed by the manufacturer. Without it, code an attacker writes to the device could survive a factory reset. The Irish NCSC also warns that persistence may survive a factory reset or a firmware update.
For that reason the NCSC tells operators not to rely on firmware updates, password changes or Strict Mode alone. The bugs need no password, Strict Mode itself has one of the flaws, and an update may neither fix the bugs nor remove a foothold that is already there.
Are these flaws being exploited?
The BSI says there is no known active exploitation of the newly found flaws. That is not the same as the devices being safe from attack. According to the Irish NCSC, attacks on internet-exposed refrigeration management interfaces began in France on Oct. 11, 2026, with a second wave starting Nov. 2. Targets included Danfoss, Dixel xweb and Copeland xweb systems. The results were unwanted defrost cycles, destroyed stock and supply disruption. Midnight Blue's post says the waves caused tens of millions of euros in spoiled food across Europe, along with some fires.
The BSI warns that a compromised controller could be loaded with malware and made unusable, and that a long outage would be likely. For a food retailer or cold-chain operator, a controller that cannot be trusted or restored quickly means a cold room it cannot manage.
Nobody has publicly identified who is behind the October and November attacks. Midnight Blue's post, citing SentinelOne, says attribution remains open and that analysts should not assume all incidents are linked to the same actor. The new flaws were found by researchers. Nothing in the sources links them to the attackers' methods so far.
Why does this matter beyond grocery stores?
Refrigeration controllers are operational technology (OT): computers that control physical equipment. Midnight Blue notes that some form of remote connectivity is often a must-have because of maintenance staffing and SLA or insurance requirements, and The Hacker News says maintenance firms can manage the AK-SM800A remotely. That convenience is the root of the problem. Midnight Blue describes the attacks so far as technically simple, and they hit management interfaces that were reachable from the internet.
The six new flaws make that exposure more dangerous. Earlier problems in these controllers included default credentials and previously known bugs that patches addressed. Now, per the researchers, an attacker can skip the login page entirely.
What It Means for Defenders
Who is affected: Anyone running a Danfoss AK-SM800A system manager on firmware 5.3.2 or earlier, which the sources confirm is vulnerable. Treat firmware 5.4.0 as vulnerable too, given the BSI's correction and the researchers' finding that it does not fix the bugs. The most urgent cases are devices whose web management interface can be reached from the internet. That includes facilities you do not run yourself but depend on, such as leased cold storage, franchise locations and refrigeration service contracts.
What to do now:
- Get the management interface off the public internet. The agencies and the researchers agree this is the main defense. The BSI says the devices should not be internet-connected at all.
- If remote maintenance is unavoidable, put access controls in front of it. The BSI calls a VPN the minimum. Midnight Blue also suggests a private APN (a private mobile data network for cellular-connected devices) or restrictive IP allow-lists, so only known addresses can reach the controller. The Irish NCSC treats IP filtering as a short-term measure, not a permanent fix.
- Do not count on patching, password rotation or Strict Mode. Per the Irish NCSC, none of these is enough alone. Midnight Blue recommends spending the effort on removing exposure instead.
- Find your exposure. Make a list of every refrigeration and building-management controller you or your contractors operate, and check how each is reached remotely. Ask your refrigeration service provider directly whether they have turned on web or cloud access.
- Assume a previously exposed device may be compromised. Because the controllers lack secure boot and persistence may survive resets, a device that was reachable from the internet cannot be considered clean just because it was reset or updated. The Irish NCSC advises checking temperature setpoints, defrost schedules, alarm settings, user accounts and remote-access permissions for changes nobody authorized. Contact the vendor and your national CERT if you see them.
- Watch for the real fix. Track Danfoss's security advisory page and the national agencies for CVE assignments and a patched firmware release. Until one ships and is independently confirmed, isolating the network is your only mitigation.
For organizations working through CMMC or similar frameworks, the lesson extends past refrigeration. Facilities and OT equipment belong in the asset inventory and in the network boundary review. A device with a web login page is a networked computer, whatever it controls.
Sources
- BSI press release: Attacks on refrigeration units, further vulnerabilities in Danfoss AK-SM800A (13 Nov 2026)
- Ireland NCSC advisory: New Vulnerabilities in Refrigeration Controllers (13 Nov 2026)
- Midnight Blue: Multiple remote code execution vulnerabilities in Danfoss AK-SM800A
- The Hacker News: Six Unpatched Danfoss Refrigeration Controller Flaws Could Allow Remote Takeover Without Login (16 Nov 2026)